[quote]Salvation (02/08/2011)[hr][quote]Subject 1 (01/08/2011)[hr]It works. try opening it in another browser
[/quote]
Ok so what Key did you use and how low should your bass sub go before you go to low on the keys ?
When you cut the Sub was that around 50 ? then the mid bass 100 to 200 ? High bass around 300 to 2k[/quote]
It was played at G#1/Ab1
Sub Bass Under 50= too low to determine pitch and its more of a feel than sound i like to have my sub cut at 200-250 hz with a lowpass to also add some body to the panned sounds .
For the Mids i like a very low sound usually stack oscillators and drop some an octave for that mid crunchiness that i like and i HP Cut everything before 60 hz and cut everything after 13k with a lowpass idk i just hate those frequencies in my mid bass but i will put the back with the other wide bass which has more high end…
As for the other Mids its just to add brightness if i want same i just cut the lows dip some of the mids and thats pretty much it…
Also i group the Mid bass Sounds and i put and EQ and Turn it into a Mid/Side EQ and remove any Low Frequencies that still might be present on the Sides just for a more clean sound
*****Another tip i will give you is if your Mids are sounding dull or too round for the Sides add a redux and lower the bitrate (dont go under 8) it makes the sound more brighter and it adds this sort off analog noise you get from analog gear and it sounds nice and if there’s a sound that’s too round for your liking it sometimes dulls it down